Section Nine To Install The Appliance (Installation Instruction) - Infinity 890 FL Owner's Manual

CHECKING THE FLUE AND FIRE OPENING

Check that the chimney conforms to the required specifications as previously stated. Examine the condition
and carry out any remedial work including removing any debris from the base.

If the flue has been used for solid fuel it should be swept prior to the installation

Prior to installing the appliance a smoke test (using a smoke bomb) should be carried out to check that
satisfactory smoke clearance has been established.

If all the smoke is not drawn into the flue, pre-heat the flue with a blowtorch or similar and re-check. If there
is any uncertainty examine for the cause and, if necessary, seek expert advice.
No combustible material should be fitted inside the fireplace opening.

When installing this appliance against a dry lined (plasterboard) wall ensure that any void between the
plasterboard and the wall is sealed with a suitable non-combustible material (i.e. plaster or mortar).

SECTION NINE To Install the Appliance (installation instruction)

GAS SUPPLY ROUTING
Use rigid or semi – rigid tube to connect the supply. Determine the gas
supply pipe route to the appliance before installing the fire.
Fixing Firebox Assembly

Slide the firebox into the fireplace open guiding the gas supply pipe
through the hole at the rear LH bottom of the firebox.

Retain the Firebox using wall plugs and screw using the four holes
within the firebox flange.

Refit the grommet over the pipe and seal around the inlet hole.

The Fireplace frame can now be located onto the firebox assembly
and retained using the six off M4 nuts provided.

Remove the gas connection cover located within the burner shelf
left hand side and connect to the restrictor elbow provided.
Note: - The isolation valve must be fitted at a angle to allow access to the
restrictor plug plus gas pressure test nipple.

At this point the fireplace or false chimney breast front will need to
be constructed.

Connect battery pack as described in section 2. (Operating the
appliance). Locate the battery pack in the holder positioned within
the fireplace frame.

Now check that a signal is being received by pointing the remote
control hand set in the direction of the appliance and press ON / OFF
Key for at least 2 seconds. On release a bleep should be heard and
the ignition process will start.
20 LT5845 (ISS 15)