Table of Contents
Advertisement
Quick Links
OWNER MANUAL
INCLUDES
USER INSTRUCTION
&
INSTALLATION & MAINTENANCE
INSTRUCTIONS
Please read these instructions carefully before you start installing or using this
appliance
Keep this booklet handy for future reference
This appliance is
For use in Great Britain or
IRELAND only
FROM INFINITY FIRES
Charlton & Jenrick Ltd
TELFORD
SHROPSHIRE
TF3 3AR
Advertisement
Table of Contents
Related Manuals for Infinity 600 CF
Summary of Contents for Infinity 600 CF
- Page 1 Please read these instructions carefully before you start installing or using this appliance Keep this booklet handy for future reference This appliance is For use in Great Britain or IRELAND only FROM INFINITY FIRES Charlton & Jenrick Ltd TELFORD SHROPSHIRE TF3 3AR...
-
Page 2: Table Of Contents
600 CF Instructions CONTENTS PAGE USERS INSTRUCTIONS SECTION ONE Introduction Consumer Protection Information Heath & Safety Notice Introduction Important Information SECTION TWO Operating Appliance Lighting the Appliance Replacing Hand Set Battery Replacing Appliance Battery SECTION THREE Cleaning Cleaning Trim and Fret or Fascia... -
Page 3: Section One
‘hazardous waste and should be disposed of at a site licensed for the disposal of industrial waste. INTRODUCTION The 600 CF as been designed and tested to the requirements of EN 613 and is suitable for use in GB (Great Britain) and IE (Ireland). ... -
Page 4: Important Information
SECTION ONE Introduction Continued The 600 CF is battery operated; therefore no mains electrical supply is required. Power to the appliance is provided by 6 high power alkaline 1.5V batteries (“C” size) (a spare set of 6 “C” batteries is supplied with the appliance An audible repeated bleep warning indicates that the appliance batteries need changing or charging (if rechargeable batteries have been used). -
Page 5: Section Two
600 CF Users Instructions SECTION ONE Introduction Continued Care must be taken to prevent any damage being caused to surrounding soft furnishing or decoration; e.g. many embossed vinyl wall coverings may become discoloured if placed too close to the appliance. Combustible material i.e. wall panelling or wallpaper must be removed from behind the fire and fire trim. - Page 6 600 CF Users Instructions SECTION TWO Operating the Appliance Continued The icon “PILOT” will appear on the LCD display. As soon as the actual room temperature falls below the SET room temperature, the system will move from standby to the high flame level. From this point it will proceed again the modulation process.
- Page 7 600 CF Users Instructions LOW BATTERY INDICATION (APPLIANCE) If you hear a repeated ‘bleep’ sound come from the appliance this indicates the appliance battery pack is low and should be changed. If this is ignored the system will go into a lock out mode, which will not allow the appliance to be used until a new set of batteries are loaded.
-
Page 8: Glass Cleaning
600 CF Users Instructions SECTION THREE Cleaning Warning: - Before you clean any part of the appliance ensures that the appliance is turned off and cold. CLEANING: TRIM or FASCIA Abrasive or chemical cleaner should never be used. CLEANING: BLACK PAINTED SURFACES ... -
Page 9: Section Four
600 CF Users Instructions SECTIONTHREE Cleaning Continued REMOVING GLASS PANEL Remove the trim, which is held in position with magnets. Remove the two 6mm wing nuts located on the bottom left hand and right hand corners of the firebox. - Page 10 600 CF Users Instructions SECTION FOUR Fuel Bed Cleaning and Layout Continued Fuel Bed Layout (LOG) Locate air tray within the slot on shelf assembly. Place 1 & 2 Log Shapes front Stainless Steel Burner Place a thin layer of...
- Page 11 600 CF Users Instructions SECTION FOUR Fuel Bed Cleaning and Layout Continued Fuel Bed Layout (LOG) Place shapes 3 to 5 Log Shapes on top of the Air Tray as shown. Bridge Log shapes 6 & 7 as shown.
-
Page 12: Section Five
600 CF Users Instructions SECTION FOUR Fuel Bed Cleaning and Layout Continued Bridge Log Shapes 12 & 13 as shown. SECTION FIVE Appliance Data NATURAL GAS PROPANE GAS Gas Type: CATEGORY I 2 H CATERGORY 1 3 P Gas Pressure: 20 mbar +/- 1.0mbar... -
Page 13: Section Six
600 CF Installation Instructions SECTION SIX Regulations and Warnings This appliance must only be installed in Great Britain or Ireland. The appliance is suitable for use on natural gas only. GB (Great Britain) This fire does not normally require purpose build ventilation. -
Page 14: Section Seven
600 CF Installation Instructions SECTION SEVEN Siting the Appliance CLASS ONE That is a conventional brick or stone chimney as used for a solid fuel appliance with an effective cross-sectional dimension of 225 x 225 mm (9” x 9”) or a lined flue with a minimum diameter of 125mm (5”). -
Page 15: Section Eight
600 CF Installation Instructions SECTION EIGHT To Install the Appliance Continue CLASS ONE INSTALLATION WITH FLEXIBLE LINER USING (GATHER HOOD OPTIONAL EXTRA Part No A-0293) Fix the gather hood assembly to the rear top of the firebox using the four fixing screws provided within the kit. -
Page 16: Checking Gas Soundness
600 CF Installation Instructions SECTION NINE Checking Operation of Fire CHECKING GAS SOUNDNESS Turn on the gas supply to the appliance and check for soundness in accordance with current codes of practice. Turn off the gas supply at the external Isolation valve. - Page 17 600 CF Installation Instructions SECTION NINE Checking Operation of Fire CHECKING FOR COMBUSTION PRODUCTS CLEARENCE IMPORTANT:-The smoke test must be carried out with the fire starting from cold. Light the fire and leave at maximum input. Close all the doors and windows.
-
Page 18: Maintenance Instructions
600 CF Maintenance Instructions SECTION TEN Maintenance GENERAL Servicing should be carried out annually by a competent person such as a GAS SAFE-registered person in accordance with the relevant regulations, to ensure the safe and correct operation of the appliance. -
Page 19: Replacement Of Oxy-Pilot Assembly
600 CF Maintenance Instructions SECTION TEN Maintenance Continued REPLACEMENT OF OXY-PILOT ASSEMBLY NOTE: If the pilot assembly is replaced it must be replaced by an identical unit from the same manufacturer and replaced as a complete unit. Follow the burner tray removal sequence. - Page 20 7. The appliance has not been subjected to misuse or accident or been modified or repaired by any person other than the authorised employee or authorised representative of Charlton and Jenrick Ltd. 8. The registration form must be returned within 3 months of purchase. INFINITY HELPDESK NUMBER 0845 5195991 LT5889 issue 7(10/12)
- Page 21 For future reference we suggest you record the following details here, and keep the receipt as proof of purchase. This information may be asked for when you contact the helpdesk. Model: Infinity 600 CF Serial No. This information can be found on the label attached to the packaging and on the data badge, which is located on the left hand side of the base of the appliance behind trim.
-
Page 22: Lt5889 Issue
Engineer Name Gas Safe Registration No. We may introduce modifications to products from time to time, and consequently the details given in this booklet are subject to alteration without notice. Infinity Fires Charlton & Jenrick Ltd Telford Shropshire TF3 3AR... - Page 23 Post Code TELEPHONE No. PRODUCT DETAILS Model: INFINITY 600 CF Serial No. Date of Purchase This information can be found on the label attached to the packaging and on the data badge, which is located on the left hand side of the base of the appliance behind trim.
- Page 24 MX (L.P.G.) Burner Tray / Box Assembly Linings (Sides, rear and top) Air Tray (Part No 5886) Glass Panel 600 CF Log set Containing 1x bag vermiculite (Part No 5902) Silicone Sealing Strip (4818) AAA Battery (3) Remote Control Hand Set...