Section Five General Points (User Instructions) - Infinity 890 FL Owner's Manual

SECTION FIVE General Points (user instructions)

Like all appliances incorporating an aerated burner a low frequency noise may be heard, particularly on the low
setting, this is quite normal and does not affect the operation of the appliance.
It is advised that a competent person service the 890 FL fire annually. The fire is more likely to provide trouble-free
operation.
Dulling and slight discoloration inside the firebox will occur adding to the realism of the appliance. This is normal.
It is important that: -
The chimney or flue is checked annually to ensure clearance of combustion products. This can be
inspected by removing the inner firebox and removal of the inspection covers located on the back and top
of the outer firebox. This can be obtained by doing the following.

Remove side covers and glass panel (refer to section 3)

Remove the log fuel bed shapes.

Lift out the air tray assembly from the location points within the shelf.

Pull out the air grill, disconnect the battery holder from the lead, and
remove.

Remove the two screw retaining the gas connection cover from
within the burner shelf and remove cover. Shut down restrictor
elbow and disconnect the 8mm inlet nut.

Undo the six fixing screws from the burner tray and lift out burner
tray assembly taking care not to damage the liners.

Remove the four M4 nuts from the front face of the inner firebox.

Taking care not to damage the top liner remove the two fixing screw
from the top of the inner firebox.

Carefully pull the inner firebox forward to clear the outer firebox
assembly.

Remove the inspection plates located within the outer firebox taking
care not to damage the sealing gaskets.

After inspection for clearance is completed, reassemble in reverse
order.
The only user removable parts are: -

Refractory Fire bed Components

Side covers and air grill.

Glass panel top fixing bracket.

Glass panel.
www.charltonandjenrick.co.uk 15 LT5845 (ISS 15)