Table of Contents
Advertisement
ENABLE AUTOMATIC PRINTING
Settings can be modified to print 1, 2 or 3 copies of the log after each cycle.
1. Verify the printer is powered ON.
2. On the control panel, verify the correct station is selected.
If necessary, press STATION SELECT to choose the
station (A or B).
3. Press SETUP.
4. Type 33 on the keypad, then press ENTER.
"Print Dynamic" displays.
5. Type the number of copies to print (1, 2, or 3) on the keypad,
then press ENTER.
6. To exit, press SETUP.
SET DELAYED START TIME
1. On the control panel, verify the correct station is selected.
If necessary, press STATION SELECT to choose the
station (A or B).
2. Press SETUP.
3. Type 28 on the keypad, then press ENTER.
"Delayed Start" displays on the top line of the screen.
4. "Day" display on the bottom line. Type the two-digit day
(01-31) on the keypad, then press ENTER.
5. "Month" displays on the screen. Type the two-digit month
(01-12) on the keypad, then press ENTER.
If zero (0) is entered for the month, the programmed cycle will run every 24 hours.
6. "Set Hours" displays on the screen. Type the two-digit hour (00-23, midnight is 00) on the keypad, then press ENTER.
7. "Set Minutes" displays on the screen. Type the two-digit minute (00-59) on the keypad, then press ENTER.
8. To exit, press SETUP.
Figure 6.12 - Enable Automatic Printing
Figure 6.13 - Set Delay Start Time
|
53
Advertisement
Table of Contents
