Table of Contents
Advertisement
46
|
SET UP FUNCTION CODE CHECKLIST
Below is a list of the functions available using the SETUP function key.
To access a SETUP function, do the following:
1.
On the control panel, press SETUP.
2.
Type the number of the function on the keypad, then press ENTER.
3.
Upon completing the function, press SETUP again to exit Set Up mode.
SETUP +
Function
Number
2
Set Date
3
Set Time
4
Display Software Version (micro, flash and SSG)
5
Input Program
6
Waterline Disinfect
8
Display Log Information
9
Disable Logging
10
Clear Log
13
Display Temperatures
17
Display Time Remaining
18
Display State Time (number & time)
21
Print Entire Log
22
Cancel Print Run
25
Print Last Run
27
Disable Weekend Delayed Starts
28
Set Delayed Start Time
29
Set Delayed Start Enable
33
Set Automatic Printing Enable
41
Incoming Water Temperature Check *
42
Display State Time and Time Remaining
43
Open Internal Water Supply Valve
88
Enter Diagnostics
This chapter provides step-by-step instructions for using these functions.
* Instructions for this function were covered earlier in the document.
Advertisement
Table of Contents
