Manual Adjustments; Remote Input - Banner Q5X Instruction Manual

Q5X Laser Triangulation Sensor With Dual Mode And IO-Link For Jam Detection Instruction Manual

Manual Adjustments

Manually adjust the sensor switch point using the
From Run mode, press either
1.
value flashes slowly.
Press
2.
flashes rapidly, the new setting is accepted, and the sensor returns to Run mode.
NOTE: When FGS TEACH mode is selected, manual adjustment moves both sides of the symmetrical
threshold window simultaneously, expanding and collapsing the window size. Manual adjustment does not
move the center point of the window.
NOTE: When Dual TEACH mode is selected, after the TEACH process is completed, use the manual
adjustment to adjust the sensitivity of the thresholds around the taught reference point. The taught
reference point is a combination of the measured distance and returned signal intensity from the reference
target. Manual adjustment does not move the taught reference point, but pressing
sensitivity, and pressing
reference target, re-teach the sensor.
RNG
When the sensor is in JRET or JBGS TEACH mode, use the
defines the minimum movement the sensor must see to determine that an object is moving (not jammed). For most
applications, the default setting is acceptable.
Remote Input
Use the remote input to program the sensor remotely.
Remote input is available from the Channel 2 menu. Set Out2 to Set.
The remote input provides limited programming options. The remote input is either Active High or Active Low depending on
the polarity setting. If the polarity is set to def or PNP, the remote input is Active High. If polarity is set to NPN, the remote
input is Active Low.
For Active High, connect the white wire to 24 V DC with a remote switch connected between the wire and 24 V DC.
For Active Low, connect the white wire to ground (0 V DC) with a remote switch connected between the wire and ground.
Pulse the remote input according to the diagram and the instructions provided in this manual.
The length of the individual programming pulses is equal to the value T: 0.04 seconds ≤ T ≤ 0.8 seconds.
Exit remote programming modes by activating the remote input for longer than 2 seconds.
24
or
to increase the setting or
decreases the sensitivity. When re-positioning the sensor or changing the
and buttons.
one time. The selected channel displays briefly, then the current setting
to decrease the setting. After 1 second of inactivity, the new setting value
or buttons to adjust the RNG value. The RNG value
© Banner Engineering Corp.
increases the
July 10, 2023