Q5X Laser Triangulation Sensor With Dual Mode And IO-Link For Jam Detection Instruction Manual
Reset to Factory Defaults Using the Remote Input
Follow the instructions below to reset the Q5X to factory defaults using Remote Input.
Eight-pulse the remote input to apply the factory defaults and return to Run mode.
The input wire function remains at remote teach input (SEt).
Locking and Unlocking the Sensor Buttons
Use the lock and unlock feature to prevent unauthorized or accidental programming changes. Three settings are available:
•
—The sensor is unlocked and all settings can be modified (default).
•
— The sensor is locked and no changes can be made.
•
—The switch point value can be changed by teaching or manual adjustment, but no sensor settings can be
changed through the menu.
NOTE: When the sensor is in either
(CH1/CH2).
When in
(CH1/CH2) or (-)(MODE) are pressed, but
When in
press and release (+)(CH1/CH2) or (-)(MODE). To enter TEACH mode, press the (SELECT)(TEACH) button and hold for
longer than 2 seconds.
Button Instructions
To enter
Holding
and pressing
Remote Input Instructions
1.
Access the remote input.
Four-pulse the remote input.
Lock or unlock the sensor buttons.
2.
Single-pulse the remote input to unlock the sensor.
Double-pulse the remote input to lock the sensor.
Triple-pulse the remote input to apply the operator
lock to the sensor
26
mode,
displays when the (SELECT)(TEACH) button is pressed. The switch point displays when (+)
mode,
displays when (-)(MODE) is pressed and held. To access the manual adjust options, briefly
mode, hold
and press
four times unlocks the sensor from either lock mode and the sensor displays
Action
Action
or
mode, the active channel can be changed using (+)
displays if the buttons are pressed and held.
four times. To enter
mode, hold
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
© Banner Engineering Corp.
and press
seven times.
Result
The sensor is ready to have the button state
T
defined and
displays.
Result
displays and the sensor returns to
Run mode.
displays and the sensor returns to
Run mode.
displays and the sensor returns to
Run mode
.
July 10, 2023