How To Adjust Tyre Pressure - Hyundai SX2 Owner's Manual

How to adjust tyre pressure

2C_TMKPrecedure_3
1. Park your vehicle in a safe location.
2. Connect the filling hose (3) of the
compressor directly to the tyre valve.
3. Plug the compressor power cord (4)
into the vehicle power outlet.
4. Adjust the tyre inflation pressure to the
recommended tyre inflation.
With the engine running, proceed as
follows:
• To increase the inflation pressure:
Switch on the compressor. To check
the current inflation pressure setting,
briefly switch off the compressor.
• To reduce the inflation pressure:
Press the button (9) on the
compressor.
NOTICE
Do not let the compressor run for more
than 10 minutes, otherwise the device
may overheat and may be damaged.
Information
• The pressure gauge may show higher
than actual reading when the
compressor is running. To get an
accurate tyre reading, the compressor
needs to be turned off.
• When reinstalling the repaired or
replaced tyre and wheel on the vehicle,
tighten the wheel nut to 79-94 lbf·ft
(11-13 kgf·m).
CAUTION
Do not use the sealant when the tyre
pressure only needs to be adjusted.
WARNING
The tyre inflation pressure must be
inflated to the proper pressure, refer to
the "Tyres and wheels" section in chapter
2. If it is not inflated, do not continue to
drive.
Call for road side service or towing.
8
8-29