Base Mounting - Grizzly T33926 Owner's Manual

Base Mounting

Position the power feeder on the table top to
determine where to drill the base mounting holes
in order to maximize power feeder swing and
adjustment options.
Use the included base bolt pattern template to
align the mounting holes. Consider the available
mounting choices for your needs: Through-Bolt
Mounting and Direct Mounting (discussed on
Page 18).
With either mounting choice, leave room to oper-
ate the hand cranks and lock levers to position the
rubber rollers parallel with the table surface and
approximately ⁄ " lower than the thickness of the
1
8
workpiece.
Shaper
4-Roller
Models
Feed
Figure 16. Typical power feed mounting on a shaper, jointer, and table saw.
Model T33926 (Mfd. Since 08/23)
Jointer
Cutter
Fence
Feed
Cutterhead
Also, aim the front of the power feeder slightly
towards the machine fence (see Figure 16)
with approximately 1° to 1.5° toe-in toward the
machine fence, so the rubber rollers lightly push
the workpiece against the fence during cutting
operations.
If cutting long or large stock that is difficult to feed
properly, use a featherboard before the power
feeder (on the infeed side) to maintain even pres-
sure and control of the workpiece against the
fence.
Table Saw
Blade
Optional
Featherboard
Fence
Feed
Fence
-17-