Xerox DocuColor 12 Color Manual page 59

2
2-25 Using AutoCal and ColorCal
8. Choose Yes in the Measure Page screen.
9. When prompted on the Control Panel, place the Kodak Gray Scale strip face down along
Place grayscale strip face down
10. Place the color measurement page face-down over the grayscale strip.
11. On the Control Panel, choose OK.
12. When prompted to Print Comparison Page (Expert Mode only), choose Yes to print a
13. When prompted to apply or overwrite the calibration, choose Yes.
14. Choose Yes to confirm.
the top of the copier glass.
Place the strip so it will be centered along the top edge of the AutoCal or ColorCal
measurement page.
Place the page at the upper-left corner of the copier/printer glass. Slide the grayscale
strip to the top center of the color measurement page. Make sure the patches on the
grayscale strip do not overlap the color patches.
Close the platen glass cover, being careful not to move the grayscale strip and color
measurement page.
Status messages display the progress of scanning and calculating measurements.
preview of the selected calibration.
Choose from a list of output profiles that use the same calibration set and press OK.
This option appears only in Expert Mode calibration.
Status messages display progress information. When calibration is complete, the
Control Panel display returns to the Functions menu.
Place color measurement page face
down over grayscale strip