2 INTRODUCTION
2
INTRODUCTION
The Renegade VOLT ES 200i is an inverter-based power source that can be run off either battery
power (DC) or 120/230 VAC. This power source is intended to be used for MMA / SMAW / Stick and
TIG / GTAW welding. The power source can be run using either one of the methods below:
•
Mains Mode
•
Battery Mode
•
AMP
+
Hybrid Mode
ESAB accessories for the product can be found in the "ACCESSORIES" chapter of this manual.
2.1
Equipment
The Renegade VOLT ES 200i is supplied with:
•
Power source
•
Battery box
•
DeWALT FLEXVOLT 12AH batteries (4 X)
•
DeWALT FLEXVOLT Four-port fast charger
•
Electrode holder, 3 m, 16 mm
•
Return cable 200A, 3 m (10 ft)
•
Mains cable, 3 m (10 ft)
•
Shoulder strap kit
•
Safety instruction manual
•
Quick start guide
2.2
Batteries and chargers
The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read
the safety instructions in the "SAFETY" chapter and then follow the charging procedures outlined.
When ordering replacement battery packs, be sure to include the catalog number and voltage.
CAUTION!
Do not use 15AH battery packs for the welding operation.
The following battery packs are only recommended:
•
FLEXVOLT 6AH
•
FLEXVOLT 9AH
•
FLEXVOLT 12AH
Only use the DeWALT battery back for the DeWALT charger. Be sure to read all safety instructions
before using your charger. Consult the represented chart below for compatibility of DeWALT chargers
to the respective DeWALT battery packs.
Catalog number
(#)
DCB546
DCB547
DCB548
0447 814 001
2
, 50 OKC
Batteries
Battery capacity
VDC
(AH)
18/54
6.0/2.0
18/54
9.0/3.0
18/54
12.0/4.0
- 14 -
Chargers/Charge
Times (Minutes)
Weight (kg)
DCB104
1.05
1.46
1.44
© ESAB AB 2023
60
75
120