Setup For Mma (Stick) Welding - ESAB CIGWELD XF190 Operating Manual

BLUEVENOM XF190
D. Settings Button
Hot Start
This feature operates in MMA (Stick) mode. The Hot
Start feature improves the arc start characteristics by
momentarily increasing the welding current to a level
above the preset amperage (Welding Current).
This parameter has an adjustment range of 0- 10.
Factory setting for Hot Start is 5.
Figure 7-2: Hot Start Adjustment
Arc Force
This feature operates in MMA (Stick) mode. The Arc
Force can be particularly beneficial in providing the
operator the ability to compensate for variability in poor
joint fit-up in certain situations. The Arc Force allows
greater penetration control to be achieved. Arc Force
is automatically increased depending on the welding
amperage.
This parameter has an adjustment range of 0- 10.
Factory setting for Arc Force is 5.
Figure 7-3: Arc Force Adjustment
60 | CIGWELD.COM.AU
OPERATING MANUAL
E. Digital Meters
In MMA (Stick) Mode the digital meters display Pre-set
VRD Voltage (not adjustable) and also display the Preview
(adjustable) Amperage. Whilst welding the digital meters
display the actual welding Voltage and Amperage of the
power source.
At the completion of welding digital meters hold the last
recorded welding voltage and amperage for 10 seconds. The
amperage meter will hold the value until; (1) any of the front
panel controls are adjusted in which case the unit will revert
to viewing mode, (2) welding is recommenced, in which case
actual welding amperage will be displayed, or (3) a period of
10 seconds elapses following the completion of welding in
which case the unit will return to viewing mode.
Anti Stick Feature (Not Shown)
This feature operates in MMA (Stick) mode. The anti
stick feature senses when the electrode sticks and
automatically reduces the current to prevent the Stick
Electrode from sticking to the work piece. This is a preset
feature and is not adjustable.

7.02 SETUP FOR MMA (STICK) WELDING

A. Ensure that the Power Source On/Off switch located on the
rear of the Power Source is in the Off position.
B. Connect the Electrode Holder lead to the positive
welding terminal (+). If in doubt, consult the electrode
manufacturer. Welding current flows from the Power
Source via DINSE type terminals. It is essential, that the
male plug is inserted and turned securely to achieve a
sound electrical connection.
C. Connect the work lead to the negative welding terminal (-).
If in doubt, consult the electrode manufacturer. Welding
current flows from the power source via DINSE type
terminals. It is essential, that the male plug is inserted and
turned securely to achieve a sound electrical connection.
D. Select MMA (Stick) mode with the process selection
control. Refer to Section 7.01 for further information.
Figure 7-4: Select MMA (Stick) Mode