Configuring Cfwd Using The Mitel Web Ui - Mitel 6905 User Manual

M C
ANAGING ALLS

Configuring CFWD Using the Mitel Web UI

Click on Basic Settings > Preferences > General.
1.
In the Call Forward Key Mode field, select a call forward mode to use on the phone.
2.
Account (default): The Account mode allows you to configure CFWD on a per account basis.
–
Pressing a configured CFWD key applies to the account in focus.
Phone: The Phone mode allows you to set the same CFWD configuration for all ac-counts (All, Busy,
–
and/or No Answer). When you configure the initial account, the phone applies the configuration to
all other accounts. (In the Mitel Web UI, only the account you configured is enabled. All other
accounts are grayed out but set to the same configuration.) Using the Mitel Web UI, if you make
changes to that initial account, the changes apply to all accounts on the phone.
Custom: The Custom mode allows you to configure CFWD for a specific account or all accounts.
–
You can configure a specific state (All, Busy, and/or No Answer) for each account independently or
all accounts. On the 6905, you can set all accounts to All On or All Off .
: If there is only one account configured on the phone, then the mode setting is ignored
NOTE
and the phone behaves as if the mode was set to Phone.
Click Save Settings.
3.
The changes takes affect immediately without a reboot.
Click on Basic Settings > Account Configuration.
4.
DND C F
AND ALL ORWARD
107