Mitel 6905 User Manual page 139

A F
DDITIONAL EATURES
PHONE FEATURE
Last Call Return
Speeddial
Conference
Transfer
Park
Voicemail
Redial
Dialing
Caller ID
Factory Default
:
NOTE
If you specify a value of 0 for the Preferred Line parameter, it disables the preferred line focus feature.
1.
If you specify a value of 0 for the Preferred Line Timeout parameter, the phone returns the line to
2.
the preferred line immediately.
PREFERRED LINE BEHAVIOR
The phone switches back to the focused line immediately after the
call ends.
The line is already specified when the speed dial is created. The
phoneswitches back immediately after the call ends.
For incoming calls, the phone switches back immediately after the
call ends.
For incoming or outgoing calls, the current behavior is that the same
line used to transfer the call does not change. For incoming calls,
the phone switches back immediately after the call transfers.
The phone switches back immediately after the call ends.
The phone switches back immediately after the call ends.
The phone switches back immediately after the call ends.
For incomplete dialing on a non-preferred line, the focus does not
change ifsome digits are entered.
If no digits are entered or digits were cleared, the focus changes to
preferredline after the time out has passed without activities.
If the Switch UI Focus To Ringing Line parameter is disabled, the
User is able to see the Caller ID when the phone switches the focus
to the ringing line.
Factory default and recovery mode clears the preferred line and
preferred line timeout parameters, and the phone operates in a
non-preferred line mode.
P L P
REFERRED INE AND REFERRED
L T
INE IMEOUT
129