Table of Contents
Advertisement
Release Both Header Latches
3. From the front of the Sunrider® top, lift and push
the top rearward to the Sunrider® position.
Sunrider® Position
4. Secure the top by using the two hook-and-loop fas-
teners provided with the Sunrider® kit, and wrap
one around the side rails on each side of the
Sunrider® top to hold it in place.
Hook-And-Loop Fastener Placement
DOOR FRAME — IF EQUIPPED WITH A
SOFT TOP
WARNING!
Do not drive your vehicle on public roads with the
door frame(s) removed as you will lose the protection
that they can provide. This procedure is furnished for
use during off-road operation only.
CAUTION!
Failure to follow these cautions may cause interior
water damage, stains or mildew:
•
Opening a door or lowering a window while the top
is wet may allow water to drip into the vehicle's
interior.
GETTING TO KNOW YOUR VEHICLE
•
Careless handling and storage of the removable
door frame(s) may damage the seals, causing
water to leak into the vehicle's interior.
•
The door frame(s) must be positioned properly to
ensure sealing. Improper installation can cause
water to leak into the vehicle's interior.
DOOR FRAME REMOVAL
NOTE:
The rear door frames must be removed first, followed
by the front door frames.
1. Using the provided #T40 Torx head driver and
ratchet, loosen the Torx head fasteners located on
the underside of each door hinge (two per door),
and remove the fasteners by pulling downward.
NOTE:
(Continued)
The fasteners will not fall out once completely loose,
as they are held in place by design.
87
CAUTION!
2
Step One
Advertisement
Table of Contents
