Table of Contents
Advertisement
To Set A Desired Speed
When the vehicle reaches the speed desired, push the
SET (+) button or the SET (-) button and release. The
instrument cluster display will show the set speed.
NOTE:
Fixed Speed Cruise Control can be used without ACC
enabled. To change between the different modes, push
the ACC on/off button which turns the ACC and the
Fixed Speed Cruise Control off. Pushing the Fixed
Speed Cruise Control on/off button will result in turning
on (changing to) Fixed Speed Cruise Control mode.
WARNING!
In Fixed Speed Cruise Control mode (ACC not
enabled), the system will not react to vehicles ahead.
In addition, the proximity warning does not activate
and no alarm will sound even if you are too close to
the vehicle ahead since neither the presence of the
vehicle ahead nor the vehicle-to-vehicle distance is
detected. Be sure to maintain a safe distance
between your vehicle and the vehicle ahead. Always
be aware which mode is selected.
If ACC is set when the vehicle speed is below 20 mph
(32 km/h), the set speed will default to 20 mph
(32 km/h).
NOTE:
Fixed Speed Cruise Control cannot be set below
20 mph (32 km/h).
If either system is set when the vehicle speed is above
20 mph (32 km/h), the set speed shall be the current
speed of the vehicle.
NOTE:
•
Keeping your foot on the accelerator pedal can
cause the vehicle to continue to accelerate beyond
the set speed. If this occurs, the message "DRIVER
OVERRIDE" will display in the instrument cluster
display.
•
If you continue to accelerate beyond the set speed
while ACC is enabled, the system will not be control-
ling the distance between your vehicle and the
vehicle ahead. The vehicle speed will only be deter-
mined by the position of the accelerator pedal.
To Cancel
The following conditions cancel the ACC or Fixed Speed
Cruise Control systems:
•
The brake pedal is applied
•
The CANC (cancel) button is pushed
•
The Anti-Lock Brake system (ABS) activates
•
The gear selector is removed from the DRIVE
position
•
The braking temperature exceeds normal range
(overheated)
•
The Electronic Stability Control/Traction Control sys-
tem (ESC/TCS) activates
•
The vehicle parking brake is applied
•
A Trailer Sway Control (TSC) event occurs
•
The driver switches ESC to Full Off mode
•
The vehicle speed is less than 15 mph (24 km/h)
(manual transmission only)
•
The clutch is pressed for more than 10 seconds
(manual transmission only)
•
The vehicle is placed in NEUTRAL for more than
10 seconds (manual transmission only)
STARTING AND OPERATING
•
The driver shifts to FIRST gear (manual transmission
only)
•
Vehicle is operating at a low RPM (manual transmis-
sion only)
•
When Off Road+ (if equipped) is enabled
The following conditions will only cancel the ACC
system:
•
Driver seat belt is unbuckled at low speeds
•
Driver door is opened at low speeds
To Turn Off
The system will turn off and clear the set speed in
memory if:
•
The Adaptive Cruise Control (ACC) on/off button is
pushed
•
The Fixed Speed Cruise Control on/off button is
pushed
•
The ignition is placed in the OFF position
•
4WD Low is engaged
To Resume
If there is a set speed in memory push the RES
(resume) button and then remove your foot from the
accelerator pedal. The instrument cluster display will
display the last set speed.
Resume can be used at any speed above 20 mph
(32 km/h) when only Fixed Speed Cruise Control is
being used.
Resume can be used at any speed above 0 mph
(0 km/h) when ACC is active.
139
4
Advertisement
Table of Contents
