GE SF6 Instruction Manual page 261

Preparing the contact surfaces
Preparing the
contact grease
Preparing the
contact surfaces
08- 2016
Installation
Installation of terminals
with preparation of contact surfaces
The contact grease is a mixture composed of Vaseline and Contactal grease.
CONTACT GREASE = 50% Vaseline + 50% Contactal grease
The table below gives the steps of preparing the contact surfaces :
Step Action
Remove the temporary screws
1 from the terminal pads X1 and
X2.
2 Dry rub with fine emery cloth.
3 Eliminate the dust produced.
4 Coat with
GREASE.
5 Wipe with a clean rag, leaving
just a thin layer of grease.
6
Rub over the grease with
waterproof abrasive
A400.
GE Information
CONTACT
paper
Diagram
X2
X1
L31- 512EN/03
3/4