Gas - Broaster E Series Installation Manual

Steps 6 & 7 only appear
on initial startup. After
that, the "Check Oil Level" display will
appear whenever the power switch is
turned on.
8. The next screen is a caution to make
sure the oil is at the oil level mark on
the capillary guard. If it is at the mark
tap the green OK button in the bottom
right corner.
9. Set the cook cycle time by tapping the
time box twice. When the keypad
appears set the cook time. The time
you set will appear above the keypad.
If it is correct, tap the enter key at the
bottom right corner.
10. Set the cook temperature by tapping
the temperature box twice. When the
keypad appears set the cook tempera-
ture. The temperature you set will
appear above the keypad. If it is cor-
rect, tap the enter key at the bottom
right corner.
11. Close the cover. The timer will start
counting down. At the end of a cook
cycle, an audible alarm will sound until
the pressure regulating valve handle is
turned to OPEN.
12. Press Cancel Auto-filter to cancel
automatic filtering if desired.

GAS:

DO NOT operate unit
without filter pan and fil-
ter pan cover in its proper position. Filter
pan cover must be completely cleaned
after each filtering cycle.
1. Clean unit as outlined in the operation
manual.
2. Make sure all controls are OFF.
3. Install cover O-ring as outlined under
see Service Manual for Troubleshooting
Instructions.
made to the burner assembly. Never
make any adjustments to the fan or gas
valve and venturi assembly.
5-2
broaster.com Manual #21307 06/20 rev 06/20
COVER in CLEANING section of oper-
ation manual.
4. Fill cooking well with cooking oil. See
PRE-COOKING PREPARATIONS in
operation manual.
5. Turn circuit breaker ON or install fuse.
6. Turn power switch to ON. The "Check
Oil Level" display will appear. Press
the green OK button then the tempera-
ture display will appear and have a yel-
low background. Also "HEAT ON" will
be displayed indicating the cooking oil
is being heated.
Check to make sure
burner is actually lit. If not
7. Check flame on top of burner. It should
be all blue and settled on the face of
the burner creating a red looking
burner surface. If it is not check to
make sure the air shutter is locked in
place.
There are no adjust-
ments required to be
8. Close the cover. The timer will start
counting down. At the end of a cook
cycle, an audible alarm will sound until
pressure regulating valve handle is
turned to OPEN.