Table of Contents
Advertisement
6.
Remove any oil or grease build-up
from Pressure Relief Valve and Pres-
sure Gauge Ports on bottom of cover.
7.
After cleaning, completely dry. Lubri-
cate O-ring with clean liquid shorten-
ing. Install O-ring in O-ring groove.
SPLASH SHIELD
Allow cover assembly to
cool before cleaning. Hot
surfaces could cause serious burns.
Clean the two-piece splash guard accord-
ing to the following instructions:
1.
OPEN cover and slide back.
2.
Rotate cover handle (1) to a centered
position.
3.
Loosen screws (2) attaching back
splash shield (3) to splash shield (4).
4.
Slide splash shield (4) forward and up
toward the end of the cover handle (1).
5.
are assembled correctly after cleaning.
The cover may not close correctly if they
are not.
6.
GAS SPRING COVERS
surfaces could cause serious burns.
Clean the gas spring cover as follows:
1.
2.
3.
4.
5.
6.
9–3
broaster.com Manual #16285 8/05 Rev: 2/14
Clean the top and underside of splash
shield and top of the cover.
Ensure back splash shield
(3) and splash shield (4)
Assemble in reverse order.
Allow cover assembly to
cool before cleaning. Hot
Lower the cooking well cover and slide
forward until it stops.
Loosen thumb screws (1) attaching
gas spring cover (2) to yoke assembly
(3).
Raise the cover off the yoke assembly.
Clean the top and underside of the gas
spring cover and the yoke assembly.
Wipe gas springs with clean cloth or
paper towel.
Assemble in reverse order.
Advertisement
Table of Contents
