GAS SPRINGS
The gas springs are required to hold the
cover, yoke and lift assembly in the raised
position.
DO NOT operate unit if
cover will not remain in
raised position. Cover is hot after cook-
ing. Falling cover could cause serious
burns.
1. See Steps 1-6 of COVER AND YOKE
REMOVAL.
ADJUSTMENTS
Height Adjustment:
Proper alignment of the yoke latches (6) and
latch column (7) is essential. Remove black
cover and turn set screw in or out to raise or
lower the yoke latch.
Centering Cover:
This is important for prevention of steam
leaks and keeping O-ring wear to a mini-
mum.
into its original position and screw
replaced after making this adjustment. If
this sign becomes worn or illegible, it
must be replaced immediately.
5-3
broaster.com Manual #17280 1/15 Rev 9/15
It is important warning
sign (8) be placed back
1. Remove screw from left side of warn-
ing sign (8) and swing out toward the
right.
2. Loosen but do not remove two cover
bolts (12) in top of splash shield (10).
3. Open and close cover several times in
cooking well to let cover seek its own
center. With cover in CLOSED posi-
tion, tighten each cover bolt a little at a
time while alternating between the
two.
4. Using a torque wrench, tighten each
bolt to a maximum torque of 180 in/lbs
or 15 ft/lbs.