Mounting; Unit Placing And Mounting Positioning Requirements; Floor Mounting - Salda RIS 700 H EKO 3.0 Mounting And Installation Instruction
Source: salda.lt/en, vetter-lufttechnik.de
Hide thumbs
Also See for RIS 700 H EKO 3.0:
Table of Contents
Advertisement
5.5.
MOUNTING
• Installation
works
should be carried out by qualified and trained staff only.
• When connecting air ducts, consider the labels on the casing of the unit.
• Before connecting to the air duct system, the connection openings of
• When connecting the ducts, the air-flow direction indicated on the device housing should be observed.
• Do not connect the bends close to
branch of the air duct in the supply air duct must be 1xD, in air exhaust duct 3xD, where D is the diameter of the air duct.
• It is recommended to use the brackets (accessories). This will reduce the vibration transmitted by the unit to the air duct system and environ-
ment.
• Sufficient space must be provided for opening the device door and filter covers.
• If the ventilation unit is
a wall-mounted
fans is admissible,
we recommend
mounting
the unit on the wall of the room where the level of noise is not significant.
• Ducts are connected to the unit in such
out maintenance,
service
and/or
The protective film is used to protect the unit during transportation. It is recommended to remove the film; otherwise, oxida-
tion signs may occur.
Before every heating season, the condensate tube must be filled with water as indicated during the first start-up!
5.5.1. UNIT PLACING AND MOUNTING POSITIONING REQUIREMENTS
Figure 5.5.1.1 Min. distance to open the door - 1,5xL; Min. distance to open the control box door - H > 400 mm.
5.5.2. FLOOR MOUNTING
• The installation should be performed having positioned the units in
• Install the supporting legs.
• The units are assembled from separate sections.
• They must be adjusted without a gradient.
• Leave space in front (2xL) so that it would be sufficient to open the doors and to remove or install a required component.
10
| EN
the
connection flanges of the unit. The minimum distance of the straight air duct between the unit and the first
device, it may transmit noise vibrations to the premises. Though the level of noise generated by the
mounting the unit
at a
distance of 400 mm from the nearest wall. Where this is not possible,
a
way that they could be easily
repair works.
Figure 5.5.1 Horizontal floor-mounting positions on floor (W=400 mm)
L
1,5xL
1,5xL
the
ventilation unit should be closed.
disassembled,
and the
coil
could be removed from the unit when carrying
H
L
the
horizontal direction only.
we recommend
W
RIS 700 H EKO 3.0 v2023.1
Advertisement
Table of Contents
