Table of Contents
Advertisement
1–2
Product Overview
Configuration DIP Switches
The Communication Module has one four position DIP switch for
setting the baud rate, protocol and checksum type. DIP switches are
located on the rear of the module (see below) and are only accessible
when the module is removed from the 160 Drive. Refer to Chapter 3
for switch configuration information.
Figure 1.2
Module Rear View
Module Latch
Expansion/Keypad Port
ON
1 2 3 4
DIP Switches
D-Shell Connector
Connector
SW1 - SW4
Advertisement
Table of Contents
