Rs1 Parameters - Allen-Bradley 160-RS1 User Manual

RS1 Parameters

Parameter Number
Drive RS1
Access
(N10:, N30:) (N13:, N33:)
101 1 Read/Write [Node Address]
102 2 Read Only [DF1 Adapter Ver]
103 3 Read/Write [Fault Mode]
104 4 Read Only [Active Protocol]
105 5 Read Only [DIP BAUD Rate]
106 6 Read Only [DIP Checksum]
107 7 Read Only [DIP Protocol]
108 8 Read/Write [EPROM Protocol]
109 9 Read/Write [EPROM Checksum]
Parameter Descriptions
This chapter provides a listing and description of the RS1 Parameters.
Important: Refer to your 160 User Manual for drive parameter
The RS1 Module contains a set of parameters that are used to define
how the module will interact with the network. These parameters may
be used to set the module's baud rate, protocol, etc. Parameters may
also be read to attain status from the module.
[Parameter Name] and Description
Address that the RS1 Module will respond to.
Drive power must be cycled before changes will take affect.
Firmware Version of the RS1 Module.
Enables forcing a drive fault for communication errors.
0 = Fault Drive Enabled
1 = Fault Drive Disabled
The current communication protocol that the RS1 is using.
0 = DF1 Point-to-Point
1 = DF1 Multi-drop
2 = Used by Rockwell Automation Field Service Personnel
Selected baud rate from DIP switches SW1-SW2.
0 = 9600 Baud
1 = 2400 Baud
2 = 1200 Baud
3 = EPROM Mode
Current checksum switch setting (selected by SW4).
BCC = 0 (OFF)
CRC = 1 (ON)
Current protocol selected by SW3.
0 = DF1 Point-to-Point
1 = DF1 Multi-drop
The communications protocol used when SW1 & SW2 are set to "On"
(EPROM Mode).
0 = DF1 Point-to-Point
1 = DF1 Multi-drop
Drive power must be cycled before changes will take affect.
The checksum mode used when SW1 & SW2 are set to "On" (EPROM
Mode).
0 = BCC
1 = CRC
Drive power must be cycled before changes will take affect.
descriptions.
6
Chapter
Min./Max.
Values Default
0 to 254 1
– None
0 to 1 0
0 to 2 0
0 to 3 0
0 to 1 0
0 to 1 0
0 to 1 0
0 to 1 0