Procedures - Allen-Bradley 160-RS1 User Manual

2–2 Quick Start for Experienced Users

Procedures

Step Action
1. Review Attention statements in the Preface.
Ensure that power has been removed to the 160 Drive.
2.
Verify that the 160 Drive is correctly installed and
3. wired. Stop Input (TB3-7, TB3-8) must be jumpered
together to start drive.
Remove Program Keypad Module or Ready/Fault
4.
Indicating Panel from the drive.
Set the RS1 Module's baud rate, protocol and check-
5.
sum type DIP switches.
6. Install the RS1 Module.
7. Connect communication cable.
8. Power up the drive and the network.
Configure the 160 Drive for the RS1 Module so the
9. drive can accept control logic and speed reference via
the network.
Set P46 - [Input Mode] to a value of "2." This will configure
the drive to accept the logic commands from the network.
Set P59 - [Frequency Select] to "1." This will configure the
drive to accept speed commands from the network.
Configure the RS1 Module parameters for your
10. application. For Example: P103 - [Fault Mode],
P114 - [Application Timeout], etc.
11. Check for proper operation.
For Further Information
Refer to . . .
160 Drive
User Manual
160 Drive
User Manual
Chapter 3
(Installation)
Chapter 3
(Installation)
Chapter 3
(Installation)
Chapter 3
(Installation)
Chapter 3
(Installation)
Chapter 8
(Using the RS1 Module
with a Programmable
Controller)
or
Chapter 7
(Using the RS1 Module
with DriveExplorer
Software)
Chapter 6
(Parameter Descriptions)