Table of Contents
Advertisement
Chapter 3
Configure XM Module in RSLogix 5000 Software
About the ControlNet
Adapter
Add the XM Module to the I/O
Configuration Tree
54
The 1440-ACNR ControlNet adapter allows XM modules to communicate
over the ControlNet network. The 1440-ACNR adapter interfaces to a Logix
controller.
When RSLogix 5000 downloads the XM module configuration to a Logix
controller, the controller attempts to establish a direct connection to each XM
module in the I/O Configuration.
The controller maintains and monitors its connection with the XM module.
Any break in the connection, such as a module fault or removal of the module
while under power, causes the controller to set fault status bits in the Input Tag
associated with the module.
For more information about the 1440-ACNR adapter, refer to the XM
ControlNet Adapter User Manual, publication ICM-UM001.
To add the XM module in RSLogix 5000 software, complete the following
steps.
1. Configure your adapter.
See the XM ControlNet Adapter User Manual, publication
UM001, for information on how to configure the adapter.
2. Right-click the 1440-ACNR ControlNet Adapter under I/O
configuration and select New Module.
Rockwell Automation Publication ICM-UM002G-EN-E - October 2016
ICM-
Advertisement
Table of Contents
