Chroma 63200 Series Operation & Programming Manual page 103

Return Parameter
Query Example
Return Example
CONFigure:VOLTage:LATCh:RESet
Description
Syntax
Parameter
Example
CONFigure:VOLTage:ON
Description
Syntax
Parameter
Example
Query Syntax
Return Parameter
Query Example
Return Example
CONFigure:VOLTage:POLarity
Description
Syntax
Parameter
Example
Query Syntax
Return Parameter
Query Example
Return Example
CONFigure:VOLTage:RANGe
Description
Syntax
Parameter
Example
Query Syntax
Return Parameter
Query Example
Return Example
CONFigure:VOLTage:PROTection
Description
Syntax
Parameter
Example
Query Syntax
Return Parameter
Query Example
Return Example
0 | 1
CONF:VOLT: LATC?
0 (OFF)
Reset Von signal.
CONFigure:VOLTage:LATCh:RESet
None
CONF:VOLT:LATC:RES
Set the voltage of loading current to on.
CONFigure:VOLTage:ON <NRf> [suffix]
For valid voltage range refer to respective specification.
CONF:VOLT:ON 1
CONF:VOLT:ON 300mV
CONFigure:VOLTage:ON?
<NR2> [Unit=Voltage]
CONF:VOLT:ON?
3.5
Set the voltage display polarity.
CONFigure:VOLTage:POLarity <NR1 | CHAR>
0 | MINUS, 1 | PLUS,
CONF:VOLT:POL 0
CONF:VOLT:POL PLUS
CONFigure:VOLTage:POLarity?
0 | 1
CONF:VOLT:POL?
0 ( MINUS )
Set voltage measurement range in CC mode.
CONFigure:VOLTage:RANGe <NR1 | CHAR>
0 | L, 1 | H
CONF:VOLT:RANG 1
CONF:VOLT:RANG L
CONFigure:VOLTage:RANGe?
0 | 1
CONF:VOLT:RANG?
1 ( H )
Set Load On protection.
CONFigure:VOLTage:PROTection <NR1 | CHAR>
0 | OFF, 1 | ON
CONF:VOLT:PROT 1
CONF:VOLT:PROT OFF
CONFigure:VOLTage:PROTection?
0 | 1
CONF:VOLT:PROT?
1 (ON)
Return the action type to Von.
Set Von=1V.
Set Von=300mV.
Return the setting of Von value.
Set voltage display to minus.
Set voltage display to plus.
Return the display polarity.
Set full-range to High.
Set full-range to Low.
Return Voltage range.
Enable Load On protection.
Disable Load On protection.
Return Load On protection.
Language Dictionary
7-7