Verizon NCM1100E User Manual page 8

1.1b/ WPS
WPS is an easy way to add supported Wi-Fi devices to your network. Press
the WPS button on the back of the Gateway to activate WPS. You will need to
activate WPS on your Wi-Fi device too. Refer to "3.1d/ Wi-Fi Protected Setup
(WPS)" on page 40.
1.1c/ LEDS
The LEDs indicate the system and connection status, and WPS activity.
System LED
Front LED Mode
System Status (O)
Bootup
Regular usage mode
Wired WAN connectivity
IP Passthrough mode
Other
http://setup.verizon.com/businessinternetgateway |
Status
System booting
Firmware update
Rest mode
In service
IPPT ( IP Passthrough)
enabled
Factory reset
Hardware error
No SIM card
No signal
01 / INTRODUCTION
LED Pattern
Soft blink white
Fast blink white
Solid white
Solid blue
Solid green
Fast blink yellow
Soft blink red
Hard blink red
Solid red
©2024 Verizon. All Rights Reserved
8