Verizon NCM1100E User Manual page 42

bASIC SETTINGS
4. After pressing the WPS button on your Gateway, you have two minutes
to press the WPS button on the client device before the WPS session
times out.
When the WPS button on your Gateway is pressed, the Status LED on
the front of your Gateway begins flashing blue. The flashing continues
until WPS pairing to the client device completes successfully. At this
time, the Status LED turns solid white.
If WPS fails to establish a connection to a Wi-Fi client device within two
minutes, the Status LED on your Gateway flashes red for two minutes to
indicate the WPS pairing process was unsuccessful. After flashing red,
the light returns to solid white to indicate that Wi-Fi is on.
Note: Wi-Fi Protected Setup (WPS) cannot be used if WPA3 security is
enabled or SSID broadcast is disabled or if MAC address authentication is
enabled with an empty white list.