Verizon NCM1100E User Manual page 14

1.2c/ SETTING UP
Before you begin, if you are replacing an existing gateway, disconnect it. Remove
all old gateway components, including the power supply. They will not work with
the new Verizon Internet Gateway for Business.
1. Plug in the Gateway. Stand it vertically on an elevated surface near a
window.
2. Wait up to 15 minutes for the system light to turn off.
The light will blink white while the Gateway is powering on and
updating software. Don't unplug.
If it turns solid red: No signal in this location. Move the Gateway to
another location.
If it blinks red: Activation error. Unplug the Gateway and plug it back in.
3. Check the signal strength. One signal bar is all you need, but you can try
to find an even stronger signal by checking different areas.
4. Wait up to 15 minutes for the Wi-Fi light to turn on.
Once it lights up solid white, you're ready to connect your devices. If it
blinks red: Activation error. Unplug the Gateway and plug it back in.
5. Connect your network devices.
Connect to your new network using the Wi-Fi name and password
printed on the rear panel of the Gateway, or scan the QR code there to
connect automatically.
http://setup.verizon.com/businessinternetgateway |
01 / INTRODUCTION
©2024 Verizon. All Rights Reserved
14