Verizon NCM1100E User Manual page 117

3. Specify the following parameters:
• Routing Entry Routing Entry – select the IP address type.
• Name – the network connection type. Name
• Destination Destination – enter the destination IP of the destination host, subnet
address, network address, or default route. The destination for a
default route is 0.0.0.0.
• Netmask Netmask – enter the network mask. This is used in conjunction with
the destination to determine when a route is used.
• Gateway – enter the IP address of your Gateway. Gateway
• Metric Metric – enter a measurement preference of the route. Typically, the
lowest metric is the most preferred route. If multiple routes exist to a
specific destination network, the route with the lowest metric is used.
4. Click Apply Apply and Apply Changes
Internet Group Management Protocol (IGMP)
IGMP allows for managing a single upstream interface and multiple downstream
interfaces of the IGMP/MLD (Multicast Listener Discovery)-based forwarding.
This function enables the system to send IGMP host messages on behalf of
hosts that the system discovers through standard IGMP interfaces. Also, IGMP
snooping allows an Ethernet switch to "listen in" on the IGMP conversation
between hosts and routers, while IGMP querier will send out periodic IGMP
queries.
To enable this function:
1. Choose the IGMP interfaces by clicking on the check boxes on the
screen.
2. Click Apply Changes Apply Changes to save changes.
http://setup.verizon.com/businessinternetgateway |
Apply Changes to save changes.
05 / CONFIGURING
ADVANCED SETTINGS
©2024 Verizon. All Rights Reserved
117