Quantum DXi4700 Upgrade Manual page 32

Quantum DXi4700 Capacity Upgrade Guide
6-68107-03 Rev C
December 2016
Cabling the System
Table 6 Connecting the
DXi4700 G1 Expansion
Modules (JBODs)
Table 7 Connecting the
DXi4700 G2 Expansion
Modules (JBODs)
32
After the components are installed in the rack, reconnect all power, SAS,
Ethernet, and Fibre Channel cables on the rear of the Node, and connect SAS
cables to any new Expansion modules.
Follow these steps to cable the DXi4700:
1 Connect each Expansion module (JBOD) using the provided 1m SAS cables.
• For DXi4700 G1 models, (see
• For DXi4700 G2 models, (see
Caution: On DXi4700 G2 models, the SAS cable locking tabs may hit the
chassis when pushed straight into the connector. Move the
cable left and right, up and down to ensure that the cable
successfully locks into place. Gently pull the connector to
confirm that the cable is locked.
Node JBOD 1
SAS port 1 (left) Primary SAS In
port (top)
SAS port 2 (right) Secondary SAS In
port (bottom)
Primary SAS Out
port (top)
Secondary SAS
Out port
(bottom)
Node JBOD 1
SAS port 1 (left) Primary SAS In
port 1 (top)
SAS port 2 (right) Secondary SAS In
port 1 (bottom)
Primary SAS
port 2 (top)
Table 6 and Figure 29).
Table 7 and Figure 30).
JBOD 2
Primary SAS In
port (top)
Secondary SAS In
port (bottom)
Primary SAS Out
port (top)
Secondary SAS
Out port
(bottom)
JBOD 2
Primary SAS
port 1 (top)
JBOD 3
Primary SAS In
port (top)
Secondary SAS In
port (bottom)
JBOD 3
Cabling the System