Quantum DXi4700 Upgrade Manual page 27

Figure 24 Installing the
DXi4700 Node in the Rack
Slide-release lock button
Installing Components in the Node
Front of Node
6 Locate the rear rail standoff on each side of the Node and lower them into
the rear J-slots on the slide assemblies.
7 Rotate the Node downward until all the rail standoffs are seated in all four
of the J-slots.
8 Press the slide-release lock buttons on both rails and slide the Node into the
rack. (Make sure the Node is squarely aligned with the rack as you slide it
in.)
9 If applicable, replace the front bezel by inserting the right side of the bezel
into the slots on the Node and then snapping the left side of the bezel into
place.
Note: You will reconnect all cables after installing any Expansion modules.
Quantum DXi4700 Capacity Upgrade Guide
Rear rail standoffs
Rear rail J-slots
Inner slide rails
Lock lever
6-68107-03 Rev C
December 2016
27