Quantum DXi4700 Upgrade Manual page 30

Quantum DXi4700 Capacity Upgrade Guide
6-68107-03 Rev C
December 2016
Figure 27 DXi4700 Expansion
Module Rails Installation
Rail front end
Latch release button
30
3 Engage the back end of the rail until it fully seats on the vertical rack flange
and the latch clicks into place. Repeat these actions to position and seat the
front end piece on the vertical rack flange.
Removing the Rails
If you need to remove the rails, pull on the blue release latch on each end piece
and unseat the rail from the rack.
Installing the DXi4700 Expansion Module
WARNING: A minimum of two people are required to lift the DXi4700
Expansion module chassis. To lift the chassis, use the slots in the
packing foam to place your hands under the sides of the chassis.
Caution: Before proceeding, ensure that all hard drive latches are completely
closed. Quantum recommends that you do not remove the hard
drives from the chassis. If they have been removed for any reason
during or after the installation, you
the same position in which they were removed.
Latches click into place in rack flange
(round or square holes)
Rail back end
must
install the hard drives in
Installing Expansion Modules