Quantum DXi4700 Upgrade Manual page 22

Quantum DXi4700 Capacity Upgrade Guide
6-68107-03 Rev C
December 2016
Figure 18 Installing a Memory
Module
22
To install the memory modules in the DXi4700 Node:
Caution: Use appropriate ESD precautions, including the use of a grounding
strap, when performing this procedure.
Caution: Handle the memory modules by the card edges and avoid touching
the components on the memory module.
1 Remove the plastic memory blank from the socket by pressing down and
out on the ejectors on each end of the socket until the memory blank pops
out of the socket (see
Memory module
Ejector latch
2 Align the memory module's edge connector with the alignment key of the
memory module socket, and insert the memory module in the socket.
Note: The memory module socket has an alignment key that allows you
to install the memory module in the socket in only one way.
3 Press down on the memory module with your thumbs until the ejector
latches snap into a locked position.
4 Repeat steps 1–3 for each memory module.
5 Replace the cooling-fan assembly:
a Align the cooling-fan assembly slots with the guide pins on the chassis
(see Figure 15).
b Slide the cooling-fan assembly into the chassis.
6 Lock the cooling-fan assembly into the chassis.
7 Replace the cooling shroud:
a Align the tabs on the cooling shroud with the securing slots on the
chassis (see Figure
Figure 18). (The plastic memory blanks are recyclable.)
Socket alignment key
19).
Installing Components in the Node