Quantum DXi4700 Upgrade Manual page 16

Quantum DXi4700 Capacity Upgrade Guide
6-68107-03 Rev C
December 2016
Figure 11 Removing the
DXi4700 Node from the Rack
Slide-release lock button
16
Note: If necessary, remove the optional screws securing the Node to the
front of the rack (behind the locking tab).
4 Locate the lock levers on the sides of the inner rails (see
each lever by rotating it up to its release position.
5 Grasp the sides of the Node firmly and pull it forward until the rail standoffs
are at the front of the J-slots.
6 Lift the Node up and away from the rack and place it on a flat, stable
surface.
WARNING: The DXi4700 G1 Node and Expansion module (JBOD) weigh
61.0 pounds (27.7 kg) and 62.6 pounds (28.4 kg) respectively.
The DXi4700 G2 Node and Expansion module (JBOD) weigh
49.4 pounds (22.4 kg) and 59.2 pounds (26.8 kg) respectively.
A minimum of two people are required to lift either chassis.
7 Press and hold the power button on the front of the Node for three seconds
to fully drain the system of stored power prior to removing the cover (see
Figure 12).
Figure
Rear rail standoffs
Rear rail J-slots
Inner slide rails
Lock lever
Installing Components in the Node
11). Unlock