Supermicro SuperServer SYS-E200-12D-10C User Manual page 35

10Gb LAN Enable/Disable
Use JPTG1 to enable or disable the 10 GbE LAN. The default setting is Enabled.
IPMI Shared LAN Feature
Set the JBM1 jumper to enable or disable IPMI shared access on LAN1.
Manufacturing Mode Select
Close pins 2-3 of jumper JPME2 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a host
server for system setting modifications. Refer to the table below for jumper settings.
Onboard TPM 2.0 Enable/Disable
Use JPT1 to enable or disable support for the onboard TPM 2.0 module. The default setting
is Enabled.
10Gb LAN Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
IPMI Share LAN Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 (Open) Enabled (Default)
Pins 1-2 (Short) Disabled
Manufacturing Mode
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode
TPM Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
35
Chapter 3 Motherboard Connections