Removing The Roof - Siemens SICHARGE D Product Information

Removing the roof

If you are assembling the cable management system during a new installation, skip these instructions and start here: Installing
the cable management (Page 81)
If you are retrofitting the cable management system on a SICHARGE D charging station, then proceed as follows to remove the
roof:
Figure 1 Removing the roof and filter bezel
1. Unlock the rear device door and lift out the device door.
2. First, pull out the filter bezel on the bottom. Then pull the filter bezel downwards.
3. Loosen the four quarter-turn fasteners and remove the filter box.
4. Loosen the M6 combi screws left and right for the roof.
5. Pull the roof off backwards and lift it down.
6. Install the filter box and fasten the filter box with the 4 quarter-turn fasteners.
Note
Hand over the roof to the owner
Hand over the dismantled roof to the owner of the charging station.
80
Installation of the cable management system
A5E53160522-AA, 11/2023