Table of Contents
Advertisement
b.
Remove both PCIe riser cages or fillers, the chassis air baffle, and the PCIe expansion tray (see
"Remove a 4U PCIe riser cage" on page
"Remove the 4U PCIe expansion tray" on page
c.
Remove the fan cage assembly (see
d.
Disengage all the drives or fillers from the two backplanes on the carrier to be removed (see
"Remove a 2.5-inch hot-swap drive" on page
connected to the two backplanes.
Notes: Following are the backplanes that are installed to the same carrier. Make sure to
disengage drives and disconnect cables from both backplanes before removing the carrier
assembly.
•
Backplane 1 and 4
1 4
•
Backplane 2 and 5
2 5
•
Backplane 3 and 6
3 6
Step 2.
Remove the drive backplane carrier assembly.
ThinkSystem SR860 V2 Maintenance Manual
142
255,
"Remove the chassis air baffle" on page
249).
"Remove the fan cage assembly" on page
140), and disconnect the signal cables that are
270, and
153).
Advertisement
Table of Contents
