Table of Contents
Advertisement
• See
https://serverproven.lenovo.com/
the system board must have the same speed, number of cores, and frequency.
• Before you install a new PHM or replacement processor, update your system firmware to the latest level.
See "Update the firmware" in the ThinkSystem SR860 V2 Setup Guide.
The following illustration shows the components of the PHM.
Figure 104. PHM components
Heat sink
1
Heat sink triangular mark
2
Processor identification label
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Procedure
Step 1.
If you are replacing a processor and reusing the heat sink.
a.
Remove the processor identification label from the heat sink and replace it with the new label
that comes with the replacement processor.
b.
If there is any old thermal grease on the heat sink, wipe the thermal grease from the bottom of
the heat sink with an alcohol cleaning pad.
for a list of processors supported for your server. All processors on
Clips to secure processor in carrier
9
Carrier triangular mark
10
Processor ejector handle
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
.
Chapter 4
Hardware replacement procedures
215
Advertisement
Table of Contents
