Table of Contents
Advertisement
Remove the M.2 backplane bracket assembly and drives
Follow instructions in this section to remove the M.2 drive backplane bracket assembly and drives.
About this task
Attention:
• Go over
"Installation Guidelines" on page 137
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Procedure
Step 1.
Make preparations for this task.
a.
Remove the top cover (see
b.
Remove the PCIe bracket cage from Zone 2 next to the power supplies (see
PCIe riser cage" on page
Step 2.
Disconnect the M.2 cables from the system board.
Step 3.
Remove the M.2 bracket assembly.
Figure 168. Removing the M.2 bracket assembly
Grasp and pull the captive screw to disengage the backplane bracket.
ThinkSystem SR860 V2 Maintenance Manual
276
to ensure that you work safely.
12).
"Remove the top cover" on page
255).
240).
"Remove a 4U
Advertisement
Table of Contents
