Table of Contents
Advertisement
About this task
Attention:
• Go over
"Installation Guidelines" on page 137
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Procedure
Step 1.
Remove the OCP Ethernet adapter.
Loosen the captive screw.
Grasp the handle, and slide the adapter out.
Figure 74. Removing the OCP Ethernet adapter
After this task is completed
1. Install a replacement unit or a filler (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install the OCP Ethernet adapter
Follow instructions in this section to install the OCP Ethernet adapter.
to ensure that you work safely.
12).
"Install the OCP Ethernet adapter" on page
185).
.
Chapter 4
Hardware replacement procedures
185
Advertisement
Table of Contents
