DIP-switches
Pin №
State
Pin 1
ON
OFF
Pin 2
ON
OFF
Hardware Installation
DIN-Rail Mounting
Mounting steps:
1. Screw the DIN-Rail bracket on with the bracket and screws in the accessory kit.
2. Hook the unit over the DIN-Rail.
3. Push the bottom of the unit towards the DIN-Rail until it snaps into place.
Wall Mounting
Screw on the wall-mount plate on with the plate and M4 screws in the accessory kit.
Description
To enable broadcast storm rate limit.
To disable broadcast storm rate limit.
To enable the power alarm.
To disable the power alarm.
Table 3
Figure 1 — Mounting the switch on a DIN-Rail
Figure 2 — Attaching brackets to the switch
3