Table of Contents
Advertisement
Chapter 5
Figure 5-4. System Board Assembly on Grounded Anti-static pad
9. Identify the slot locations for the DIMM pair(s) being added:
10. Install the DIMM pairs:
a. Spread the latches outward on each slot receiving a DIMM.
b. Remove a DIMM from its anti-static bag, handling the module by its
edges.
c. Align the notches on the DIMM with the slot keys on the slot (see
Figure 5-5).
d. Press the DIMM into the slot until the latches close.
CAUTION
Do not rock the DIMM into place, but apply firm and even
pressure. If a gap exists between the retaining latches and the
DIMM, remove and replace the module until no gap exists.
All manuals and user guides at all-guides.com
Table 5-1. Paired Memory Slots
Slot 1A and Slot 1B
Slot 2A and Slot 2B
Slot 3A and Slot 3B
Slot 4A and Slot 4B
Installing Additional Memory
57
Advertisement
Table of Contents
Troubleshooting
