Installing Hot-Swap Mass Storage - HP NetServer LH 6000 Installation Manual

All manuals and user guides at all-guides.com
Chapter 4
You can change this boot order using the Setup utility (press [F2] during
the boot process. See Chapter 10, "Configuring the HP NetServer."
NOTE Use the Symbios (SCSI) Configuration Utility to configure the
HP NetServer to ignore the onboard SCSI channels and to
select a different PCI slot for boot devices. Refer to the
Symbios (SCSI) Configuration Utility on the HP NetServer
Online Documentation CD-ROM under Information
Assistant/NetServer LH 6000/LH 6000r/Configure.

Installing Hot-Swap Mass Storage

The procedure for installing additional hot-swap mass-storage is the same for all
HP NetServer versions.
CAUTION Protect the drive from static electricity by leaving it in its
anti-static bag until you are ready to install it. Before handling
the drive, touch any unpainted metal surface to discharge
static electricity. When you remove the drive from the
anti-static bag, handle it only by the frame.
Do not touch the electrical components. Place the drive on the
anti-static bag whenever you set it down.
1. Remove necessary filler panels:
a. Verify that the drive cage is unlocked prior to removing panels.
b. Press in the locking latch and insert your fingers.
c. Using your fingers, pull the blue filler panel straight out
(see Figure 4-5).
44
Installing Mass Storage Devices