Replacing The Lh 6000 Pedestal Covers - HP NetServer LH 6000 Installation Manual

All manuals and user guides at all-guides.com
Chapter 3
4. Remove the top cover by loosening the thumbscrew, pulling the cover
forward and then slightly sideways to disengage it. Lift it up and away
from the chassis (see Figure 3-8).
5. Remove the right cover by loosening the thumbscrew and pulling the cover
forward to disengage it. Lift it outward and away from the chassis (see
Figure 3-8).
Left Cover
Figure 3-8. HP NetServer LH 6000 Covers

Replacing the LH 6000 Pedestal Covers

1. For each of the side covers, insert the two metal tabs, at the end opposite
the handle, into the two openings at the top and bottom corners of the
chassis. Hold the cover in place, but do not slide the tabs in completely.
2. Align the four, widely spaced, metal tabs on the cover's long, top edge
against the top edge of the four widely spaced openings on the top of the
chassis.
3. Hold the top of the cover in this position with one hand, while pressing the
bottom edge of the cover with the other hand until the cover is completely
flush against the chassis.
36
Opening and Closing the HP NetServer
Top Cover
Right Cover