Configuring The Hp Netserver - HP NetServer LH 6000 Installation Manual

All manuals and user guides at all-guides.com
Chapter 1
14. Power up the HP NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
Go to the next section, "Configuring the HP NetServer."

Configuring the HP NetServer

1. Turn on the monitor. Press the power-on button on the HP NetServer, and
press the eject button on the CD-ROM drive. Place the HP NetServer
Navigator CD-ROM in the drive and close the drive. Press the Reset
button. If the system fails to restart, follow the instructions on the screen.
NOTE
To fully configure the HP NetServer, all the rack components
must be cabled and online (though not necessarily installed in
the rack.) If printed instructions are required; a local or
network printer must be connected.
Refer to Chapter 10, "Configuring the HP NetServer."
2. When HP Navigator starts, you can set the time and date, and change the
display language.
3. Read the README File: Select "README File" from the HP Navigator
Main Menu. The README file contains the latest information to help you
install your HP NetServer.
4. Run DiagTools: To verify the NetServer hardware as shipped, run
DiagTools by first creating a DiagTools flexible diskette(s) from the HP
NetServer Navigator CD-ROM. For more information on how to use
DiagTools to detect all processors and memory on the system board, refer
to the online NetServer DiagTools Error Reference and User Guide.
5. Install Information Assistant: It is easier to use Information Assistant from
a standalone workstation than from the NetServer where you are
performing the installation. Install Information Assistant from the HP
NetServer Online Documentation CD-ROM.
Go to Chapter 11, "Information Assistant," for information on how to
access your online documentation.
6
Setting Up the HP NetServer LH 6000/6000r