Removing The Lh 6000 Pedestal Covers - HP NetServer LH 6000 Installation Manual

All manuals and user guides at all-guides.com
Chapter 3
4. Check that the four closely spaced metal tabs are in their four openings at
the rear of the HP NetServer. The cover is secure when all edges are flush
against the chassis and you cannot easily shift it.
5. Gently slide the cover until the back edge snaps into place.
6. Tighten the thumbscrew at the front of the side cover.
7. For the top cover, place the cover onto the chassis. Align the five tabs on
the left side of the cover with the slots in the chassis.
8. Slide the top cover back to the rear of the chassis and tighten the
thumbscrew.
9. Return the NetServer to the rack. Replace the screws removed from the
front and rear.
10. Hold the bezel at 90 degrees to the left side of the NetServer. Snap the
bezel clamps onto the hinge posts by pressing the bezel onto the hinge.
When the bezel is snapped into place, swing the bezel closed.

Removing the LH 6000 Pedestal Covers

CAUTION
Do NOT operate the NetServer for more than 30 minutes with
any cover (including power supplies and disk drives)
removed. Otherwise, damage to system components may
result due to improper cooling airflow.
1. Unlock the bezel, using the supplied key, and remove the key from the
front of the NetServer. The bezel connects to the front of the NetServer
chassis with two snap-in connectors at the top front of the chassis and two
tabs that fit into two slots on the bottom front of the chassis.
2. To remove the bezel, pull it forward until it unsnaps, then lift the bezel
forward and upward from the chassis face (action 2 and 3 of Figure 3-7).
34
Opening and Closing the HP NetServer