Installing Hot Swap Hard Drives - HP ProLiant ML150 Operation Manual

Installing and Configuring
Figure 2-8: Removing cold swap hard drive
7. Place the drive in an electrostatic protected container.
Do not stack drives.
8. Close the lower bezel, the upper bezel, and then the side panel.
NOTE: If you are not replacing the drive, place a filler panel in the drive slot. Operating the HP server
without filler panels in empty SCSI drive slots may cause the HP server to suffer thermal damage.

Installing Hot Swap Hard Drives

Use the following steps to install hot swap hard drives:
1. Unlock the hot swap key lock above the hot swap mass storage.
2-12
HP CONFIDENTIAL Codename: Stone Soup Part Number: 343329-001 Last Saved On: 8/14/03 10:09 AM
CAUTION: Protect the drive from static electricity by leaving it in its anti-static bag until you
are ready to install it. Before handling the drive, touch any unpainted metal surface to
discharge static electricity. When you remove the drive from the anti-static bag, handle it only
by the frame.
Do not touch the electrical components. Place the drive on the anti-static bag whenever you
set it down.
HP ProLiant ML150 Server Operations and Maintenance Guide