Step 4: Installing Mass Storage Devices - HP NetServer E 800 Installation Manual

Setting Up the HP NetServer E 800

Step 4: Installing Mass Storage Devices

•
The NetServer is internally limited to 7 mass storage shelves.
The flexible disk drive and CD-ROM drive, which are standard on all
models of the HP NetServer E 800, occupy shelves 1 and 2 respectively.
•
If a backup tape drive is used, it will occupy shelf 3.
•
Shelves 4, 5, 6, and 7 are available for up to four SCSI hard drives and at
least one is required for the boot drive.
•
IDE drives are not supported in this NetServer.
CAUTION Do not connect high voltage differential (HVD) SCSI devices
on the SCSI bus or you will damage the other devices.
1. Remove the Drive Cage by loosening the three captive screws.
Hard Disk
Drive Cage
(removable)
2. Install the SCSI hard disk drive.
6
Top of Chassis (Side view)
Shelf 1
Shelf 2
Shelf 3
Captive Screws (3)
Shelves 4-7 (4)
Front of
HP NetServer