Table of Contents
Advertisement
Valve Programing
5
Unit Capacity (Not Shown If Timer Mode Was Selected In 2nd Step)
IMPORTANT!
!
This setting will only appear if the either (M) Meter or (tM) Time Meter mode from the previous setting was selected.
User will not see this setting if (t) Timer mode was selected. The system default is 1000 gallons with the option to
change the unit measurement and the capacity of the water treated before the system goes through a regeneration.
It is recommended to set the unit of measurement at (gAL) gallons and also calculate the correct amount of gallons
the system can treat by going through the worksheet on page 22 of owner's manual.
Set Unit Measurement - Gallons, Liters or Cubic Meters
Gallons
gAL
(Recommended)
A: Press SETTINGS button to adjust the
unit capacity setting.
B: Press UP or DOWN buttons to
change units.
Press the SETTINGS button to
accept and continue.
20
L
M 3
Liters
Have questions? Call 1-800-980-3335
(Recommend Setting To Gallons For US)
Cubic Meters
11:30
SEt- 3 C-U
FLASHING
11:30
01000
gAL
FLASHING
Advertisement
Table of Contents
